Solid wood flooring offers a warm and natural feel underfoot, enhancing the beauty and elegance of any space. However, it is more sensitive compared to other flooring options, so proper care and maintenance are essential to preserve its appearance and longevity. Here are some key tips for maintaining solid wood floors: 1. Keep the floor dry and clean at all times. Avoid using excessive water or alkaline cleaners, as they can dull the finish and damage the protective coating. For light dirt or dust, use a dry mop or a slightly damp mop that's well-wrung out. Apply wax every one to two months, making sure to clean up any moisture or stains before applying it. 2. If there's a water leak or a wet spot on the floor, wipe it up immediately. Avoid exposing the floor to direct sunlight or heat sources like ovens, as this can cause it to dry too quickly and lead to cracks. 3. Do not leave plastic sheets or newspapers on the floor for long periods, as they can trap moisture and cause the finish to become sticky or lose its shine. Avoid placing hot items directly on the surface—use mats or trivets instead to protect the paint layer from scalding. 4. If the floor gets stained, act quickly to remove it. For oil stains, use a cloth, a damp mop, or a mixture of warm water and a small amount of dish soap. Neutral soapy water can also be used for gentle scrubbing. If the stain is stubborn, try lightly sanding with fine-grit sandpaper or a steel wool pad. For ink, drink residue, or dye stains, wipe with a cloth soaked in furniture wax first. If that doesn't work, combine with a bit of steel wool and wax. For burns caused by cigarette butts, use a wax-dampened cloth to restore the area. For ink stains, apply wax and gently rub it in. If necessary, follow up with steel wool and wax again. 5. After installation, avoid prolonged exposure to direct sunlight, as UV rays can cause the floor to crack or fade over time. Place furniture on rubber pads or soft materials to prevent scratches on the finish. 6. If the floor becomes lifted or peels, remove it promptly, clean off the old adhesive, and reapply new glue. For damaged areas, use 400-grit sandpaper with soapy water, then clean and dry. Apply touch-up paint, let it dry, and then seal it with a coat of lacquer. After 24 hours, lightly sand with 400-grit paper and polish with wax for a smooth finish. ASHOWER , https://www.ashower.com