Solar Panels,Solar Panel Mono,Solar Power Panels China Searun Solar Solution Co., Ltd. , https://www.searunsolar.com
Hansa Gasoline Generator
After the new generator or sealed Hansa generator has run in (the first 50 hours) after the running-in operation, the following maintenance work is required: Clean or replace the air filter Replace the engine oil Change or wash the filter element of the oil filter Re-tighten the parts Bolt and screw new Hansa generator should avoid sudden increase in load or high-speed operation, use the manufacturer's recommended lubricant as much as possible, do not mix the use of different brands of lubricants, lubricants contain various additives, different brands of lubrication Oil mixing will degrade lubricating properties and cause abnormal wear of moving parts. When filling the fuel tank, the filling port should be equipped with a filter and a filter cloth should be better. The fuel must be left in the tank for more than 24 hours to allow the water and impurities to precipitate. Use the drain plug of the daily tank regularly. The head drains water and sediment from the bottom. Regular maintenance and planned maintenance are the key to prolong the service life of the engine. The inspection cycle and maintenance items should be adjusted according to the purpose and use conditions and the properties of fuel oil and lubricating oil. If necessary, repair should be carried out in advance as much as possible. Technicians complete regular maintenance and maintenance. High-quality imported Hansa generator sets are often valuable, rational use, attention to routine maintenance, prevention of early wear and tear, prolong their service life, and allow them to always start quickly and put into a good state of preparation, and truly make the best use of it.