Experts teach you to properly install integrated ceiling

The installation of integrated ceilings has always been one of the headaches for consumers, and whether the installation is correct or not is directly related to the service life and safety of the integrated ceiling.

Today, the building materials home market has generally used integrated ceilings. The integrated ceiling has also been favored by consumers because of its high service life, environmental protection and other characteristics, but it has caused consumers to have troubles in installing the integrated ceilings. The right or wrong is directly related to the service life and safety of the integrated ceiling.

Pre-installation preparation: Before installation, we must first ensure that there is no water leakage in the space where the kitchen ceiling needs to be installed, and that there are no cracks. Ensure that the corresponding facilities such as the water circuit have been laid. Then, check whether the mounting surface has enough strength. If it does not meet the requirements, it should take reinforcement measures; according to the height of the pre-installed electrical appliances, calculate the height of the room left after installing the ceiling to facilitate the edge line. installation.

In order to meet the various needs during the installation process, we also need to prepare the tools before installation: tape measure (measurement length and height), transparent water pipe (level measurement of the wall), ink fountain (wall bullets), equilateral right angles Triangular ruler (edge ​​angle cutting etc.), scissors (subtle trimming), cutting machine (cutting keel, edge trimming), polishing machine (trimming of raw material edges), hammer (wall punching), pistol Drill (drilling of keel and other materials), diamond drill (drilling of tiled wall), steel arranging (flashing of edged bar), wooden hammer (leveling gusset), hammer (knocking nail), 10 Inch 8-inch wrench (screw nut), steel pliers (clamp material), twist drill (material drilling), impact drill (wall drilling), word / Phillips screwdriver (screwing screw), wiring board (connection Power supply), test pencil (test charged or not), saw bow, saw blade (trimmed cutting material), wallpaper knife (fine trim) and so on.

The installation of the corner line will determine the installation height and level of the integrated ceiling.

When the tile is stuck to the ceiling, take a 230-240cm high point on the side of the wall, fix the point of overlap on the other side of the wall with a transparent pipe, and then use the diamond drill to drill the hole.

If the height of the ceiling can be determined by the height of the tile, the length of the wall can be 3cm * the length of the wall can be used. The wooden bar is fixed on the wall above the tile with a steel nail and the ink stick pops up on the wooden bar according to the determined installation height. The horizontal line installs the edge strip.

The edge strips are cut to the actual length, and the two ends are angled at an angle of 45° using an equal-angled square ruler and then sawn out with a hacksaw blade at 45° (Note: Since the corners are not always 90°, they should be taken at the actual angle) and will be intercepted. After the finished edge strips are worn out with steel burrs, when the edge strips are fixed to the wall, the spacing between the screws should be 30-40 cm. The cut corners must be aligned without gaps.

Today, integrated ceiling has replaced the traditional ceiling, occupying the entire home building materials market, and gradually loved by the majority of consumers, consumers can correctly grasp the installation and use of ceilings, is conducive to the better development of integrated ceiling industry!

Ceiling integrated ceiling ceiling installation space home room electrical building materials market